|
Remove resistor: R1396, R1400, R1402 on the main unit of the radio.
Press and hold down the "MHZ" and "REV" buttons on the front panel
of the radio, while powering on the radio.
Modification is complete.
New frequency:
VHF RX 108 - 180 MHz
VHF TX 136 - 174 MHz
UHF RX 320 - 999 MHz
UHF TX 410 - 470 MHz
----------------------------------------------------------------
The following received from YAESU. In response to a question
regarding skipping memory channels in scan.
FT-7100M - Memory Skip Scanning
When you have some continuously-active channels in memories, you may wish
to skip them for scanning, but still have them available for manual
selection using the Main Dial.
To mark a memory to be skipped during scanning, use the following procedure:
1. Recall the memory channel to be skipped. Note: Memory Channel "1" may
not be skipped.
2. Press and hold in the V/M key for « second (as though you were going
to store this channel into another memory).
3. Press and hold in the TONE key for « second. A small "p" icon will
appear to the bottom of the memory channel number, indicating it is
to be ignored during scanning.
4. To re-enable a "skipped" memory channel, repeat the above procedure:
recall the skipped memory channel using the Main Dial, press and hold
in V/M for « second, then press and hold in the TONE key for « second
to re-enable the channel.
Regards AA4VT
Return to
the mods-e-h file section.
|