COIL FORMS

Coil forms are used to hold a specified number of turns on a specified diameter former. The coil form may or may not be used in conjunction with a coil form "tuning slug". A tuning slug in a coil form leads to greater inductance with fewer turns.

Very good examples of coil forms surrounded by metal shields are the I.F. cans in AM / FM Radio Receivers as in figure 1 below.

Figure 1 - coil forms surrounded by metal shields

The shielded coil forms are indicated by "OSC" for the oscillator inductor and the "IFT" cans are the IF transformers tuned to 455 Khz. These shielded coil forms used as the IF transformers (IFT) probably have something like 140 turns wound on the primary which is a relatively tiny coil form and would yield an inductance of around 680 uH at a reasonable "Q".

Some other examples of these coil forms with and without the metal shield are in figure 2 below.

Figure 2 - coil forms with and without the metal shield

I can't remember now where I found this photo. These coil forms are numbered from 1 through 5. Number 1 is a coil form with a tuning slug (often called a "screw core" or "threaded core") and surrounded by a "cup core" to give increased inductance. By screwing the tuning slug in and out we are able to get wide variations in inductance. One example of these type of coil forms, sometimes also called "variable inductors" might be a former and cup core combination which produces say a nominal inductance of 68 uH per 100 turns over the frequency range of 1 to 10 Mhz.

If we wanted 12 uH at 5 Mhz we might select this combination of screw core and cup core. To determine the number of turns required we take 90% of the AL / 100 turns factor (i.e. 90% of the 68 uH = 61.2) To calculate the turns required we take the square root of our desired inductance (12 uH) divided by the AL (61.2) or (SQRT [ 12 / 61.2]) = 0.4428 which is then multiplied by 100 to give us 44.28 turns. Therefore we would wind 44 turns on our former. The tuning slug or "screw core", "threaded core" could give us an inductance variation of as much as 1.5 : 1

Number 2 could simply be number 1 enclosed in a metal shield (copper) to prevent interaction with adjacent components. Number 3 simply has a plastic cup core to protect the windings, it would have a dramatically reduced value of inductance in the absence of a magnetic cup core. Numbers 4 and 5 have no cup cores at all. I'm not even certain number 5 has a screw core.

These are simply a few examples of the hundreds of sizes and possible variations available.

See related topics and links below.

Link to this page

NEW! - How to link directly to this page

Want to create a page link to me from your site? It couldn't be easier. No HTML knowledge required; even the technophobes can do it. All you need to do is copy and paste, the following code. All links are greatly appreciated; I sincerely thank you for your support.

Copy and paste the following code for a text link:

<a href="http://www.electronics-tutorials.com/basics/coil-forms.htm " target="_top">visit Ian Purdie VK2TIP's "Coil Forms" Page</a>