KOBRA 16 MAXI
Building instructionsIn order to simplify the cabinet construction as far as possible, we
have done without the chamfers shown in the photo. If you prefer to include
the all-round front chamfer, you will need the following information:
Angle: 30°
Width: 10 mm
The cabinet consists of boards stuck together (butt jointed), making
construction a simple matter. First of all, the individual boards are cut
to size (refer to cutting list), stuck together (butt jointed) as shown
in the drawing and firmly clamped for the duration of the drying time using
sash-cramps or parcel tape. Once the cabinet has been completely built,
the cut-outs are made for the speakers, bass tube and terminals using a
jig-saw. The last job is the surface treatment, i.e. painting, veneering
or adhesive film.
Inner damping
The damping of the speaker uses four mats of damping material pushed
into the cabinet through the bass cut-out. To this end, the mats are folded
once longways and once cross-ways and pushed into the cabinet in such a
way that the space behind the tube remains free and the rest of the space
inside the cabinet is loosely filled.
| Component parts list for 1 box | |||
| Tweeter: | MOREL MDT29 | 1 piece | |
| Bass-midrange driver: | W 170 S 8 Ohm
BEST BASS OR MORELMW162 BEST MIDDLE |
1 piece | |
| Crossover: | " | ||
| Bass reflex tube:BR 15.34 | VISATON-14,7CM
MOREL-5CM |
1 piece | |
| Damping material: | 2 bags | ||
| Wood screws: | 3,5 x 19 mm | 3 pieces | |
| 3,5 x 25 mm | 9 pieces | ||
| ................ | |||
| Cabinet parts list for 1 box | |||
| Parts | Size (mm) | Quantity | |
| Material: 19 mm chipboard or MDF | |||
| Front and rear panel | 762 x 192 | 2 | |
| Side panel | 800 x 230 | 2 | |
| Top and bottom panel | 230 x 192 | 2 | |
