P1_____________10K Log.Potentiometer R1,R2__________33K 1/4W Resistors R3_____________33R 1/4W Resistor R4_____________15K 1/4W Resistor R5,R6___________1K 1/4W Resistors R7____________680R 1/4W Resistor R8____________120R 1/2W Resistor R9____________100R 1/2W Trimmer Cermet C1,C2__________10µF 63V Electrolytic Capacitors C3____________100µF 25V Electrolytic Capacitor C4,C7_________470µF 25V Electrolytic Capacitors C5_____________47pF 63V Ceramic Capacitor C6____________220nF 63V Polyester Capacitor C8___________1000µF 25V Electrolytic Capacitor D1___________1N4148 75V 150mA Diode Q1____________BC560C 45V 100mA PNP Low noise High gain Transistor Q2____________BC337 45V 800mA NPN Transistor Q3____________TIP31A 60V 4A NPN Transistor Q4 ___________TIP32A 60V 4A PNP Transistor SW1___________SPST switch SPKR__________3-5 Watt Loudspeaker, 8, 4 or 2 Ohm impedance
Device purpose:
This amplifier was designed to be self-contained in a small loudspeaker box. It can be feed by Walkman, Mini-Disc and CD players, computers and similar devices having line or headphone output. Of course, in most cases you'll have to make two boxes to obtain stereo.
The circuit was deliberately designed using no ICs and in a rather old-fashioned manner in order to obtain good harmonic distortion behaviour and to avoid hard to find components.
The amplifier(s) can be conveniently supplied by a 12V wall plug-in transformer.
Closing SW1 a bass-boost is provided but, at the same time, volume control must be increased to compensate for power loss at higher frequencies.
In use, R9 should be carefully adjusted to provide minimal audible signal cross-over distortion consistent with minimal measured quiescent current consumption; a good compromise is to set the quiescent current at about 10-15 mA.
To measure this current, wire a DC current meter temporarily in series with the collector of Q3.
 |
 |
 |