Ultrasonic Dog Whistle
By Tomaz Lazar - Ljubljana, Slovenia.
It's well known that many animals are particularly sensitive to high-frequency sounds that humans can't hear. Many commercial pest
repellers based on this principle are available, most of them operating in the range of 30 to 50 kHz.
My aim was, however, to design a slightly different and somewhat more powerful audio frequency/ultrasonic sound generator that could be used
to train dogs. Just imagine the possibilities - you could make your pet think twice before barking again in the middle of the night or even
subdue hostile dogs (and I guess burglars would love that!).
From what I've read, dogs and other mammals of similar size behave much differently than insects. They tend to respond best to frequencies
between 15 and 25 kHz and the older ones are less susceptible to higher tones. This means that an ordinary pest repeller won't work simply
because dogs can't hear it. Therefore, I decided to construct a new circuit (based on the venerable 555, of course) with a variable pitch
and a relatively loud 82 dB miniature piezo beeper.
The circuit is very simple and can be easily assembled in half an hour. Most of the components are not really critical, but you should keep
in mind that other values will probably change the operating frequency. Potentiometer determines the pitch: higher resistance means lower
frequency. Since different dogs react to different frequencies, you'll probably have to experiment a bit to get the most out of this tiny
circuit. The circuit is shown below:
Despite the simplicity of the circuit, there is one little thing. The 10nF (.01) capacitor is critical as it, too, determines the frequency.
Most ceramic caps are highly unstable and 20% tolerance is not unusual at all. Higher capacitance means lower frequency and vice-versa. For
proper alignment and adjustment, an oscilloscope would be necessary. Since I don't have one, I used Winscope. Although it's limited to
only 22 kHz, that's just enough to see how this circuit works.
There is no need to etch a PCB for this project, perf board will do. Test the circuit to see how it responds at different frequencies. A 4k7
potentiometer in conjunction with a 10nF (or slightly bigger) capacitor gives some 11 to 22kHz, which should do just fine. Install the
circuit in a small plastic box and if you want to, you can add a LED pilot light. Power consumption is very small and a 9V battery should
last a long time.
Possible further experimentation: I'm working on an amplified version of the whistle to get a louder beep. All attempts so far haven't
been successful as high frequency performance tends to drop dramatically with the 555. Perhaps I could use a frequency doubler circuit - I
just don't know and I've run out of ideas. One other slightly more advanced project could be a simple "anti-bark" device with a
sound-triggered (clap) switch that sets off the ultrasonic buzzer as soon as your dog starts to bark.
