The three-transistor circuit in Fig 1 costs less than $10 to build, uses commonly available components, and consumes less than 10 mA from a single 9V battery. If you wind coil L₁, as the figure shows, the circuit receives signals in the 5- to 15-MHz short-wave band. You can add turns to or subtract turns from L(or change C₂) to receive other frequencies.

Q₁, a 10¢ bipolar transistor, acts as a high-gain regenerative stage and amplifies microvolt-level signals at the antenna up to hundreds of millivolts to drive diode-detector D₁. In addition to providing high gain, regeneration also greatly increases the Q (selectivity) of the circuit, producing a high-Q circuit, which can use low-cost coils (or free hand-wound coils).

Using a high-transconductance bipolar transistor for Q₁ rather than a vacuum tube or JFET provides much more gain per microamp of current. However, in previous bipolar circuits of this type, the regeneration level has been difficult to control. In this circuit, R₁ and R₂ provide a large amount of negative bias at the emitter of Q₁ to achieve smooth control. Rallows for user control of the regeneration. You should adjust the pot so that Q₁ is just at the threshold of oscillation where both gain and selectivity are maximum.

Q₂and Q₃, a two-transistor amplifier, which has sufficient output level to directly drive headphones or a small speaker, amplify the detected audio signal output from D₁. R₃can become a volume control if you replace it with a 2-kOhms potentiometer and connect C₃to its wiper. R₄ and C₄ form a lowpass filter that maintains circuit stability and improves the receiver's sound quality. D₂, D₃, and D₄ implement a low-cost voltage regulator to keep the voltage supplying Q₁fairly constant, which minimizes drift.

This receiver works with a short whip antenna, which you can connect directly to the top of tuning-capacitor C₂, or you can use an outside antenna for better reception. When you use an external antenna, Cmust decouple the antenna's capacitance from L₁. The regenerative stage of Q₁operates at less than 30 µW (50 µA at 0.6V). This low power, combined with the use of a small capacitor for C₁, prevents the detector (if it oscillates) from interfering with other receivers in the area. This problem was common in the 1920s and 1930s when tube-type regenerative receivers of this type, dissipating several watts of power, caused interference.