top1.gif (15308 bytes) top2.gif (8943 bytes) top3.gif (4270 bytes) top4.gif (3559 bytes) top5.gif (4399 bytes)
middle1.gif (1934 bytes) main/middle2.gif (3230 bytes)
.
 

Telephone amplifier


     While talking to a distant subscriber on telephone, quite often we feel frustrated when the voice of the distant subscriber is so faint that it is barely intelligible. To overcome the problem, circuit of an inexpensive amplifier is presented here. It can be assembled and tested easily. There is no extra power source needed to power up the circuit, as it draws power from the telephone line itself. The amplifier will provide fairly good volume for the telephone conversation to be properly heard in a living room. A volume control is included to adjust the volume as desired.
    The circuit is built around IC LM386. Diodes D6 and D7 are used to limit the input signal strength. Transformer X1 is a transistor radio's output
transformer used in reverse. As
original secondary (output) winding
is connected in series with the telephone lines, the speech signals passing through the lines cause change in the magnetic flux in the core of transformer and thereby induce signal voltage across the primary winding. This audio signal is used as input for IC LM386.
Diodes D2 through D5 connected in bridge configuration constitute a
polarity guard so that the amplifier is powered with correct polarity, irrespective of the line polarity, Zener
diode D1 may have any breakdown
voltage between 6 and 12 volts
range. e.

    There is no need of a separate power switch as the circuit energises (via the normally open contacts of the cradle switch) when one lifts the handset.
The circuit may be wired on a general-purpose PCB or by etching a PCB for this circuit.
    The circuit can be easily tested by connecting a 6 volts supply to line terminals 1 and 2. A hissing sound will be heard from the loudspeaker. Now connect 6V AC from a transformer to terminals 1 and 2 and observe hum in the loudspeaker. The volume of the hum can be changed through potentiometer VR1. Diodes D6 and D7 limit the input below ± 700 mV.
The circuit is to be connected to the telephone lines in series with the telephone instrument, as shown in the figur

teleph1th.gif (2842 bytes)

Click on the image to view the full