300 Watts RF Amplifier

 



Schematic of circuit

It will put out a conservatively-rated 300 watts across the FM broadcast band.

PCB :

Components placement :

All holes indicated by black dots MUST be connected to the solid foil side on the back of each board. These are the ground connections. A simple feed through, or a short piece of buss wire will do.

The flange on the MRF141G must be mounted to a heat spreader, a copper plate 5/16" thick and 6" x 8", which is then mounted to the heatsink with 6-32 machine screws, if the heatsink is drilled and tapped.
I recommend buying the two transformer assemblies, rather than trying to build them, because 15-ohm hardline is not easy to find. I have had good results ordering them from:

RF power systems
17827 North 26th St.
Phoenix, AZ 85032
1-602-867-0389


The part numbers are TUI-9F and TUO-9F and the cost is about $20 each.

This amplifier has the notable characteristic of variable gain control via the bias adjustment trim pot. It may be used in conjunction with an SWR bridge circuit to limit power output in the event of high SWR caused by damage to the antenna during a storm, or someone inadvertently disconnecting the coax transmission line. If you wish to implement a failsafe shutdown system that is triggered by loss of PLL lock, I still recommend a power supply cutoff relay for total safety however.

Component List :

Component

Value

Qty

 

Component

Value

Qty

R1 1k, 0.5 W

01

  C3 0.1 uF Ceramic Chip

01

R2 10k, 0.5 W

01

  C4 , C5 , C12 1000 pF Ceramic Chip

03

R3 330 Ohms , 2 W

01

  C6 , C7 0.01 uF Ceramic Chip

02

R4 1k ( Pot. )

01

  C8 0.47 uF Ceramic Chip

01

R5 68 KOhm , 0.25 W

01

  C13 300 pF, 2x150 pF Ceramic Chips

01

R6 Thermistor 10K at 25 degC Sk at 75degC

01

  L1 10 Turns AWG #16 Enameled Wire

01

R7 2k, 0.5 W

01

  L2 Ferrite Beads over AWG #16 Wire

01

R8 , R9 25 Ohm Microwave Power Resistor

02

  L3 , L4 Lead Lengths of R8 and R9

02

C1 , C9 1.5-20 pF Compression Mica

02

  FET MRF141G

01

C2 200 pF Ceramic Chip

01

       
 

Component

Value

Qty

T1 9:1 RF Transformer

01

T2 1:9 RF Transformer

01

 
   
   
   

Reference :

Download the page | RF / Video | Circuits | Electronics | Home

Last Updated : September 17, 2001

1