30-Meter QRP (CW)

30-Meter QRP (CW)
by P. Wyns, ON7WP (Belgium)

This transmitters' intended purpose is for morse-code only in the 30 meter band (10Mhz). It is a low-power QRP type and needs to be connected to your existing tranceiver. The harmonic rejections on the prototype were measured at 40dB on 20Mhz and 50dB on 30Mhz.

Component Layout.

[30m-pcb]

1-5/16" x 2" (34mm x 52mm) double-sided.

Parts List

  R1 = 100K       C1 = 22nF   L1,L3 = 820 nH           BNC connector
  R2 = 4K7     C2,C5 = 1nF       L2 = 1.8uH            Coolrib for T2
  R3 = 12K        C3 = 100nF     L4 = T-94-2 (Amidon)  Morse-key, single pole
  R4 = 18 Ohm     C4 = 100pF     T1 = BC547            All-metal case
xtal = 10Mhz   C6,C7 = 330pF     T2 = 2N2219(A)

Additional Notes
The transmitter is build as a Colpitts Oscillator with a strong 2N2219(A) transistor. HF-output of the oscillator is 100 to 500 mW, depending on the supply voltage of 5 to 20 Volts. The transmit frequency is stabilized with the 10Mhz crystal. A slight detuning is possible by putting a 150pF trimmer capacitor between C2 and the xtal. The oscillator signal is taken from the collector of T2 by induction and via a low-feedthrough filter and guided to the output. This particular filter is called "Chebychev" and uses standard E12 type values. The oscillator is keyed by T1, which biases as long as the morse-key is open and the base of T1 is at ground level. By keying the morse-key T1 is blocked and allows T2 to freely oscillate. For best results, use the double sided pcb as shown above. Coil L4 exists of Primary 6 turns and secondair 3 turns of 0.5mm magnet wire on a Amidon T-94-2 donut. Outside diameter is 24 mm and inside diameter is 14mm; the A(l) value is 84uH per 100 turns and permeability of 10. T2 needs a coolrib! The whole circuit needs to be mounted in an all-metal/aluminum case. If you're unable to obtain an all-metal case, then use a roll of self-sticking aluminum tape (available from your hardware store), just make sure that all individual pieces of aluminum-tape are conducting with each other. Works fine. Don't forget the coolrib on T2. Good luck!